User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-86 Chapter 5: Management Functions
Flashing BIOS by manually uploading a BIOS file
Manually upload a BIOS file to flash the BIOS of the client device. The BIOS file
uploaded and flashed with will be added to the BIOS Cache.
1. Select
Manually Upload BIOS File
in the
BIOS
Flash
Type
field.
2. Click on
Browse
to select a BIOS file, then click
OK
to confirm the BIOS file
was uploaded successfully. The uploaded BIOS file will also be added to the
BIOS Cache
3. Click on
Flash BIOS
.
Flash Mode
will default to
Hardware Mode
.
5. Select if you wish to perform a
Normal Mode
BIOS flash or if you wish to do
a
Recovery Mode
BIOS flash, then click
OK
.
Performing a
Recovery Mode
BIOS Flash will reset all BIOS configurations,
and remove all previous configurations.