User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
4-7ASUS Control Center Express
Editing the threshold value
Some items such as Voltage items, or Fan items allow you to edit the threshold
values. Click on the item you wish to edit, then click on
Save
once you are finished
editing.
• The threshold options for each item may vary.
• Some items may not have a threshold value you can edit.
High threshold
When the value exceeds this threshold value, the sensor will display
Warning
(Yellow)
.
When the value exceeds this threshold value by 20%, the sensor will
display
Critical
(Red)
.
Low threshold
When the value is below this threshold value, the sensor will display
Warning
(Yellow)
.
When the value is below this threshold value by 20%, the sensor will display
Critical
(Red)
.
Monitor
Enable or disable monitoring of this item.
Check zero value
Enable or disable the check for zero value. When
enabled
, a warning will
display if the fan speed for a fan is 0. When
disabled
, if the fan speed for a
fan is 0, it will be recognized as a removed fan (not connected).