User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
3-26 Chapter 3: Deploy Management
4. You can view the agent deploy and update progress in the Mission Center.
• Agent updates can only be performed on client devices that are online. If
you selected multiple devices and some of the devices selected are offline,
you can view the failure to deploy and update message in the Mission
Center, and update these devices when they are online.
• If the connection is unstable during the agent update process, the agent
update status on the Mission Center will be displayed as
Finish
, and the
task name will become grayed out and unclickable, the agent on the client
device will be reverted to the version prior to the update. You can update
the client device again when it is online.
• If the client device was powered off or restarted during the agent update
process, the agent update status on the Mission Center will be displayed
as
Finish
, and the task name will become grayed out and unclickable, and
will resume the update process once the client device has restarted and is
in OS.
• Certain functions may be affected if the main ASUS Control Center
Express server version has already been updated to v1.4.x or above but
the client device agent has not been updated (v1.3.x).