User’s Manual

3-8 Chapter 3: Deploy Management
Client device IP address
This will allow you to set the client device’s IP as the scan range.
1. Click on
Scan IP range
and select
Manual IP Address
.
2. Select
Mask
to scan the subnet mask range of the client device, or select
Boundary
to set a starting IP and ending IP to scan in the
Range
field.
Mask:
IP Source
Enter the client device’s IP.
Subnet Mask
Select a subnet mask range to scan.
NIC
Select the IP of the main server network card to scan.
Start Address
Enter the start IP address of the client device you wish to
scan.
End Address
Enter the end IP address of the client device you wish to
scan.
NIC
Select the IP of the main server network card to scan.
Boundary: