User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
3-7ASUS Control Center Express
3.2.2 Scanning an IP range
Depending on your network environment, you may set an IP range to scan for
devices, helping you deploy agents quickly and efficiently.
Main Server IP address
This will allow you to set the main server’s IP as the scan range.
1. Click on
Scan IP range
and select
Local IP Address
.
2. Select the main server’s IP address in the
IP Source
field and the subnet
mask range to scan in the
Subnet Mask
field.
3. Click
OK
to begin scanning.
4. Double click on a device in the scan results to edit the device information,
then click
Save
once you are finished.
5. Once you have finished editing the scanned device information, select the
devices you wish to deploy agents to, then click
Deploy
.
If ACC CSM is already installed on the client device, please export and backup
the data first, then check the
Remove the client device’s ACC agent
option
before deploying.
6. After the deployment is completed, you may view the deploy status in the
deploy list.