User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
8-13ASUS Control Center Express
Account
Set the default account to log into the client device’s DASH
remote management controller.
Password
Set the default password to log into the client device’s DASH
remote management controller.
DASH port
Set the port for DASH (default: 664).
TLS
Enable or disable TLS (Transport Layer Security).
DASH Account:
Set the default login account used to log into the client DASH remote management
controller. Click on
Save
to save the changes made.
The account and password entered should match the account and password
for the client device’s DASH remote management controller.
Account
Set the default account to log into the client device’s BMC remote
management controller.
Password
Set the default password to log into the client device’s BMC
remote management controller.
Management Port
Set the port for BMC (default: 443).
BMC Account:
Set the default login account used to log into the client BMC remote management
controller. Click on
Save
to save the changes made.
The account and password entered should match the account and password
for the client device’s BMC remote management controller.