User’s Manual

5-138 Chapter 5: Management Functions
Select Time Zone
Select the time zone from the Select Time Zone drop
down menu.
Automatic NTP Date & Time
Enable or disable automatic time and date
synchronization with the NTP server.
Primary NTP Server*
Allocate the primary NTP server to automatically update
the date and time.
Secondary NTP Server*
Allocate the secondary NTP server to automatically
update the date and time.
Automatic PTP Date & Time
Enable or disable the PTP server to automatically
update the date and time.
PTP Interface*
Set the PTP server interface.
PTP Preset*
Set the PTP preset type to SlaveOnly or MasterSlave
modes (default: SlaveOnly).
PTP Transport*
Set the PTP transport type to IPv4 or Ethernet modes
(default: IPv4).
PTP Ipmode*
Set the PTP Ipmode to Unicast or Multicast modes.
PTP Unicast IP*
Set the Master IP address when PTP is in Unicast
mode.
PTP Delay Mechanism*
Set the PTP delay mechanism to E2E or P2P (default:
E2E).
PTP Inbound Latency*
Set the PTP inbound latency in nanoseconds (default:
0ns).
PTP Outbound Latency*
Set the PTP outbound latency in nanoseconds (default:
0ns).
PTP Priority1*
Set the priority of the PTP clock between 0 and 128 for
the Master and 255 for the Slave.
PTP Max Master Capacity*
Set the max master capacity of the PTP clock (default:
5).
PTP Log Request Delay*
Set the PTP log request delay (default: 1).
Panic Mode*
Set PTP clock to not reset if jump is more than 1 second
(default: unchecked).
Settings marked with an asterisk (*) are only available when the checkbox for
Automatic NTP Date & Time
or
Automatic PTP Date & Time
is selected.
Date & Time
This page allows you to set the date and time on the BMC.