User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-129ASUS Control Center Express
Login
Allows you to enter the account and password that ASUS Control Center Express
will use to log into the client device’s BMC remote management controller. After
successfully logging in, the BMC remote management controller will automatically
switch to the newly logged in account.
Management Port
Allows you to set the management port used for the BMC web console.
• The management port must match the port used by the BMC web console
or BMC functions will not be available.
• To set the default management port for all devices, click on
Settings
in
the menu bar of the main control panel, then click
Options
>
General
Configuration
, and scroll down to
BMC Account
>
Management Port
.
LED Interval
Allows you to set the state and blink interval of the client device’s LED indicator.
LED On
The client device’s LED indicator will turn on.
LED Off
The client device’s LED indicator will blink on and off.
LED Interval
The client device’s LED indicator will turn on for the specified
interval, then return to the “off” state and blink on and off.