User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-106 Chapter 5: Management Functions
•
Wired Interface Settings
Displays and allows you to configure wired network settings of the client
device.
Link State
Displays the wired network link state.
Link Policy
Displays the wired network link policy.
MAC Address
Displays the wired network MAC address.
Respond to ping
Displays the wired network ping response protocol.
IP State
Displays the wired network IP state.
IP Address
Displays the wired network IP address.
IP Default Gateway
Displays the wired network IP default gateway.
IP Subnet Mask
Displays the wired network IP subnet mask.
IP Domain Name Server
Displays the wired network IP Domain Name Server.
Editing wired interface IP
Click on
Edit
in the Wired Interface Settings block to set the client device’s
IP from either
IP synchronizes with the operating system
,
Automatically
use DHCP server
, or
Static IP address
.
Setting ping packet response
Click on
Set ping packet response
in the Wired Interface block to set
the client device’s wired network pin packet response from either
Disable
,
ICMP
,
RMCP
, or
ICMP & RMCP
.