User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-59ASUS Control Center Express
Power On (G0/S0)
Power on the client device through the DASH remote
management controller.
Power Off - Soft (G2/S5)
Power off the client device through the DASH remote
management controller.
Power Off - Hard (G3)
Force the client device to power off through the DASH remote
management controller when the OS is unresponsive.
Power Cycle - Soft off
(G2/S5)
Restart the client device after shutting down from the OS
through the DASH remote management controller.
Sleep - Deep (G1/S3)
Set the client device to enter sleep mode (G1/S3) through the
DASH remote management controller.
Master Bus Reset
Resetting the hardware of the client device through the DASH
remote management controller.
Hibernate (G1/S4)
Set the client device to enter hibernate mode (G1/S4) through
the DASH remote management controller.
Power Cycle - Hard Off
(G3)
Powering off and restarting the client device through the DASH
remote management controller.
Power Off - Soft Graceful
(G2/S5)
Normal shut down via the OS of the client device through the
DASH remote management controller.
Master Bus Reset
Graceful
Normal shut down and resetting the hardware of the client
device through the DASH remote management controller.
Power Cycle (Graceful
Soft Off) (G2/S5)
Normal shut down via the OS then restarting the client device
through the DASH remote management controller.
Power Control
Allows you to remotely execute power control functions on the client device
through the DASH remote management controller, such as a system restart.