User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-53ASUS Control Center Express
• When selecting multiple client devices to set the account and password,
ensure to select client devices with the same remote management
controller.
• The KVM password must contain 8 characters, and must contain
uppercase characters (A-Z), lowercase characters, numbers (0-9), and
special characters.
• Ensure the client device’s RTL8117 is enabled if it uses RTL8117 for
remote management control, and this is a new machine which is used for
the first time or has been reset to factory settings. In the device’s BIOS,
navigate to
Advanced
> RTL8117 setting, then enable RTL8117.
• If an agent has been deployed to the client device, you can also enable the
client device’s RTL8117 management controller through the BIOS setting
function of ASUS Control Center Express.
• You cannot update the RTL8117 remote management controller firmware
if KVM is enabled. If you wish to update the RTL8117 remote management
controller firmware please disable KVM first.