User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-49ASUS Control Center Express
4. You can view the status and results of setting the account and password in
the Mission Center. If the account and password setting was successful and
the account and password match, ASUS Control Center should automatically
log into the client device’s remote management controller, and also allow
you to begin using the
OOB - Control
functions.
• You can also set the account and password for a single device with DASH
remote management controller through
Account Management
on the
DASH
Device Management Information
page. For more information on
Account Management please refer to
5.7.7 Account Management
.
• MEBx is an Intel
®
BIOS extension option and setting for Intel
®
client
devices. The account and password set for MEBx is not the Intel
®
vPro
remote management controller account and password.
• The password for vPro Account must be at least 8 characters long, and
must contain one uppercase character (A-Z), numbers (0-9), and one
special character.
• The password for RTL8117 must be at least 8 characters long, and must
contain uppercase characters (A-Z), lower case characters (a-z), and
numbers (0-9).