User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
2-11ASUS Control Center Express
(continued on the next page)
OOB-Control*
Power
Control
Master Bus Reset
Resetting the hardware of the
selected device(s) through the
remote management controller.
Hibernate
(G1/S4)
Setting the selected device(s) to
enter hibernate mode (G1/S4)
through the remote management
controller.
Restart Computer
to BIOS
Setting the selected device(s) to
enter BIOS after a restart through
the remote management controller.
Power On to
BIOS
Setting the selected device(s)
to enter BIOS after powering on
through the remote management
controller.
Restart Computer
to IDE-R Floppy
Setting the selected device(s)
to enter IDE-R floppy drive after
a restart through the remote
management controller.
Power On to
IDE-R Floppy
Setting the selected device(s)
to enter IDE-R floppy drive after
powering on through the remote
management controller.
Restart Computer
to IDE-R CDROM
Setting the selected device(s) to
enter IDE-R ODD after a restart
through the remote management
controller.
Power On to
IDE-R CDROM
Setting the selected device(s)
to enter IDE-R ODD after
powering on through the remote
management controller.
Sleep - Light (G1/
S2)
Setting the selected device(s) to
enter sleep mode (G1/S2) through
the remote management controller.
Power Cycle -
Hard Off (G3)
Powering off and restarting the
selected device(s) through the
remote management controller.
Diagnostic
Interrupt (NMI)
Setting the selected device(s) to
print error report and restarting
through the remote management
controller.
Power Off - Soft
Graceful (G2/S5)
Normal shut down via the OS of
the selected device(s) through the
remote management controller.
Power Off - Hard
Graceful (G3)
Normal shut down via the hardware
of the selected device(s) through
the remote management controller.