User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-110 Chapter 5: Management Functions
Removing a system defense filter
To remove a system defense filter(s), select the system defense filter(s) you
would like to remove, then click
Remove Filter
.
•
System Defense Policy
This item will check incoming and outgoing packets to see if they match or
do not match the conditions set in the filter, then act according to the settings
of the policy.
Click on
Refresh
to refresh the System Defense Policy list to the latest updated
state.
Adding a system defense policy
1. Select the system defense filters you would like to add a policy to in the
System Defense Filters list, then click
Add Policy
.