User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-88 Chapter 5: Management Functions
If you wish to disable an activated trust zone list, select
Disable
from the Trust
Zone Mode field drop down menu.
• The main server IP address cannot be removed from an activated trust
zone list, ensure that the main server IP address is not included in the IP
sections you would like to remove.
• If a main server’s IP address was changed due to other reasons, and
is already included in an activated trust zone of a client device, you will
not be able to perform remote management control functions on the
client device through the main server with the new IP address as it is not
included in the client device’s trust zone. You can set the new main server
IP address on the client device through BIOS >
Advanced
>
RTL8117
Settings
.