User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-73ASUS Control Center Express
Watchdog*
Enable or disable the Watchdog monitoring function.
If the Watchdog function is enabled and
the client device triggered the Watchdog
function causing the client device to restart,
the Watchdog function will be reverted to
the default disabled state. Ensure to re-
enable the Watchdog function for the client
device.
Clear CMOS
Clears the BIOS setup information through RTL8117
for when the client hangs due to overclocking or other
errors.
Ensure the client device is completely
powered off before clearing CMOS. Power
the client device on after the clearing the
CMOS.
Set Password
Set an RTL8117 encryption password.
Restart the client device once you have set
the new password for the changes to take
effect.
Restart Service
Restart service through RTL8117.
KVM
Enable or disable KVM.
* These functions only appear if an agent is already deployed to this device and if you switch from Software
Mode to Hardware Mode