User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-52 Chapter 5: Management Functions
5.5 Management Control Overview
The Management Control options allow you to manage a client device remotely
which is connected via a management LAN port, supports a remote management
controller, and also allows out-of-band management.
To access
Management Control
, click on
located at the top right menu bar.
5.5.1 Scanning for devices
You can scan for client devices which support the Management Control functions
by clicking on
Scan
or
Scan IP range
. Clicking on a device from the scan results
will redirect you to the
Management Control Information
page.
For more information on scanning an IP range, please refer to
3.2.2 Scanning
an IP range
.