User’s Manual

5-49ASUS Control Center Express
5.4.2 Using OOB - Control functions
To use the OOB - Control functions you can either:
• Select the client device(s) you would like to execute OOB - Control functions
on, then click on
Select Function
>
OOB - Control
and select a function to
use.
• Click on
then perform a
Scan
or
Scan IP Range
, select the client
device(s) you would like to execute OOB - Control functions on, then click on
Select Function
and select a function to use.
Please see the table below for the list of the OOB - Control functions available for
the different remote management controllers:
Functions List DASH RTL8117 vPro
Power
Control
Power On (G0/S0)
V V V
Power Off - Soft (G2/S5)
V V V
Power Off - Hard (G3)
V V V
Power Cycle - Soft off (G2/S5)
V V V
Sleep - Deep (G1/S3)
V V
Master Bus Reset
V V
Hibernate (G1/S4)
V V
Restart Computer to BIOS
V
Power On to BIOS
V
Restart Computer to IDE-R Floppy
V
Power On to IDE-R Floppy
V
Restart Computer to IDE-R CDROM
V
Power On to IDE-R CDROM
V
Sleep - Light (G1/S2)
V
Power Cycle - Hard Off (G3)
V
Diagnostic Interrupt (NMI)
V
Power Off - Soft Graceful (G2/S5)
V
Power Off - Hard Graceful (G3)
V
Master Bus Reset Graceful
V
Power Cycle (Graceful Soft Off) (G2/S5)
V
Power Cycle (Graceful Hard Off) (G3)
V
WatchDog
WatchDog Enable
V
WatchDog Disable
V
BIOS
Smart BIOS
V
Clear CMOS
V
Account
Management
Set Password
V V
Login (DASH)
V
System
Restart service
V
(continued on the next page)