User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-44 Chapter 5: Management Functions
MEBx is an Intel BIOS extension option and setting for Intel client devices. The
account and password set for MEBx is not the Intel vPro remote management
controller account and password.
• The password for vPro Account must be at least 8 characters long, and
must contain one uppercase character (A-Z), numbers (0-9), and one
special character.
• The password for RTL8117 must be at least 8 characters long, and must
contain uppercase characters (A-Z), lower case characters (a-z), and
numbers (0-9).
• You can also set the account and password for a single device with DASH
remote management controller through
Account Management
on the
Device Management Information
page. For more information on Account
Management please refer to
5.7.7 Account Management
.
• If the client device selected has multiple DASH remote management
controller accounts you can switch accounts through
OOB - Control
>
Account Management
>
Login (DASH)
.
The password for RTL8117 must be at least 8 characters long, and must
contain uppercase characters (A-Z), lower case characters (a-z), and numbers
(0-9).
For DASH
a. Click on
Select Function
>
Account Management
>
Login (DASH)
.
b. Enter the account and password ASUS Control Center will use to log
into the client device’s remote management controller, then click
Save
.