User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 CPU Configuration
- 3.6.2 Platform Misc Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 CPU Storage Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 USB Configuration
- 3.6.10 HDD/SSD SMART Information
- 3.6.11 NVMe Configuration
- 3.6.12 Thunderbolt(TM) Configuration
- 3.6.13 PCH-FW Configuration
- 3.6.14 Network Stack Configuration
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: RAID Support
- Chapter 5: Multi GPU Support
- Appendix
1-24
Chapter 1: Product Introduction
Chapter 1
14. Addressable RGB LED connector
This connector is for individually addressable RGB WS2812B LED strips or WS2812B
based LED strips.
The addressable RGB LED connector supports WS2812B addressable RGB LED strips
(5V/Data/Ground), with a maximum power rating of 3A (5V) and a maximum of 60 LEDs.
Before you install or remove any component, ensure that the ATX power supply is
switched off or the power cord is detached from the power supply. Failure to do so may
cause severe damage to the motherboard, peripherals, or components.
• Actual lighting and color will vary with LED strip.
• If your LED strip does not light up, check if the addressable RGB LED strip is
connected in the correct orientation, and the 5V connector is aligned with the 5V
header on the motherboard.
• The addressable RGB LED strip will only light up under the operating system.
• The addressable RGB LED strip is purchased separately.