User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 CPU Configuration
- 3.6.2 Platform Misc Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 CPU Storage Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 USB Configuration
- 3.6.10 HDD/SSD SMART Information
- 3.6.11 NVMe Configuration
- 3.6.12 Thunderbolt(TM) Configuration
- 3.6.13 PCH-FW Configuration
- 3.6.14 Network Stack Configuration
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: RAID Support
- Chapter 5: Multi GPU Support
- Appendix
ASUS Pro WS X299 SAGE II
1-17
Chapter 1
5. Fan and Pump connectors
The Fan and Pump connectors allow you to connect fans or pumps to cool the
system.
• The CPU_FAN connector supports the CPU fan of maximum 1A (12 W) fan power.
• W_PUMP+ function support depends on water cooling device.
• Connect the fan of your water cooling kit to the AIO_PUMP connector.
• DO NOT forget to connect the fan cables to the fan connectors. Insufcient air
ow inside the system may damage the motherboard components. These are not
jumpers! Do not place jumper caps on the fan connectors!
• Ensure the cable is fully installed into the connector.
Header Max. Current Max. Power Default Speed Shared Control
CPU_FAN 1A 12W Q-Fan Controlled A
CPU_OPT 1A 12W Q-Fan Controlled A
CHA_FAN1 1A 12W Q-Fan Controlled -
CHA_FAN2 1A 12W Q-Fan Controlled -
AIO_PUMP 1A 12W Full-Speed -
W_PUMP+ 3A 36W Full-Speed -
M.2_FAN 1A 12W Q-Fan Controlled -