User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 CPU Configuration
- 3.6.2 Platform Misc Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 CPU Storage Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 USB Configuration
- 3.6.10 HDD/SSD SMART Information
- 3.6.11 NVMe Configuration
- 3.6.12 Thunderbolt(TM) Configuration
- 3.6.13 PCH-FW Configuration
- 3.6.14 Network Stack Configuration
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: RAID Support
- Chapter 5: Multi GPU Support
- Appendix
5-8
Chapter 5: Multiple GPU Support
Chapter 5
5.2.3 Installing three SLI-ready graphics cards
Refer to the documentation that came with your graphics card package to install the device
drivers.
To install three SLI-ready graphics cards:
1. Prepare three SLI-ready graphics
cards.
2. Insert the three graphics cards into the
PCIEX16 slots. If your motherboard
has more than two PCIEX16 slots,
refer to Chapter 1 in this user manual
for locations of the PCIEX16 slots
recommended for multi-graphics card
installation.
3. Ensure that the cards are properly
seated on the slots.
4. Align and rmly insert the SLI
®
bridge connector to the goldngers on each graphics
card. Ensure that the connector is rmly in place.
5. Connect two independent auxiliary power sources from the power supply to the two
graphics cards separately.
6. Connect a VGA or a DVI cable to the graphics card.
Goldfingers
SLI
®
bridge