User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 CPU Configuration
- 3.6.2 Platform Misc Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 CPU Storage Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 USB Configuration
- 3.6.10 HDD/SSD SMART Information
- 3.6.11 NVMe Configuration
- 3.6.12 Thunderbolt(TM) Configuration
- 3.6.13 PCH-FW Configuration
- 3.6.14 Network Stack Configuration
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: RAID Support
- Chapter 5: Multi GPU Support
- Appendix
5-2
Chapter 5: Multiple GPU Support
Chapter 5
5.1.3 Installing two CrossFireX™ graphics cards
The following pictures are for reference only. The graphics cards and the motherboard
layout may vary with models, but the installation steps remain the same.
To install two CrossFireX™ graphics cards:
1. Prepare two CrossFireX™-ready
graphics cards.
2. Insert the two graphics card into the
PCIEX16 slots. If your motherboard
has more than two PCIEX16 slots,
refer to Chapter 1 in this user manual
for the locations of the PCIEX16 slots
recommended for multi-graphics card
installation.
3. Ensure that the cards are properly
seated on the slots.
4. Align and rmly insert the CrossFireX™
bridge connector to the goldngers on
each graphics card. Ensure that the
connector is rmly in place.
Goldfingers
CrossFireX™ bridge
(bundled with
graphics cards)
The CrossFireX™ bridge is only required for selected graphics cards.