User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Installation Information
- Chapter 3: Web-based User Interface
- 3.1 Web-based user interface
- 3.2 Dashboard
- 3.3 Sensor
- 3.4 System Inventory
- 3.5 FRU Information
- 3.6 Logs & Reports
- 3.7 Settings
- 3.7.1 Date & Time
- 3.7.2 External User Services
- 3.7.3 KVM Mouse Setting
- 3.7.4 Log Settings
- 3.7.5 Manage Licenses
- 3.7.6 Media Redirection Settings
- 3.7.7 Network Settings
- 3.7.8 PAM Order Settings
- 3.7.9 Platform Event Filters
- 3.7.10 Services
- 3.7.11 SMTP Settings
- 3.7.12 SSL Settings
- 3.7.13 System Firewall
- 3.7.14 User Management
- 3.7.15 Video Recording
- 3.7.16 Fan Control
- 3.7.17 PSU Redundancy
- 3.8 Remote Control
- 3.9 Image Redirection
- 3.10 Power Control
- 3.11 Locator LED
- 3.12 Maintenance
- Appendix
ASUS IPMI Expansion Card
3-51
Enable Timeout
Enable or disable Timeout.
Start Date
The firewall rule will become effective from this
date.
This item is only configurable if
Enable
Timeout
is enabled.
Start Time
The firewall rule will become effective from this
time.
This item is only configurable if
Enable
Timeout
is enabled.
End Date
The firewall rule will expire on this date.
This item is only configurable if
Enable
Timeout
is enabled.
End Time
The firewall rule will expire at this time.
This item is only configurable if
Enable
Timeout
is enabled.
Rule
Allow or block this firewall rule.
Port Firewall Rules
This page allows you to create and manage existing firewall settings based on ports.
• Existing Port Rules
This page displays the list of existing firewall port rules.
• To view the page, the user must at least have Operator privileges.
• To add or delete a firewall, the user must have Administrator privileges.
• To ensure the date and time of the firewall rule works properly, make sure to set the
BMC system time before setting the firewall.
• Port 80 is blocked for TCP/UDP protocols.
• Click on the
x
icon to delete a port rule from the list.
• Add New Port Rule
This page allows you to add IP firewall port settings for the BMC.
Port Single (or) Range Start
Specify the port or start of a range of Port
Addresses.
• Port value ranges from 1 to 65535.
• Port 80 is blocked for TCP/UDP
protocols.
Port Range End
Used to configure the Port or end of a range of
Port Addresses.
(continued on the next page)