User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Installation Information
- Chapter 3: Web-based User Interface
- 3.1 Web-based user interface
- 3.2 Dashboard
- 3.3 Sensor
- 3.4 System Inventory
- 3.5 FRU Information
- 3.6 Logs & Reports
- 3.7 Settings
- 3.7.1 Date & Time
- 3.7.2 External User Services
- 3.7.3 KVM Mouse Setting
- 3.7.4 Log Settings
- 3.7.5 Manage Licenses
- 3.7.6 Media Redirection Settings
- 3.7.7 Network Settings
- 3.7.8 PAM Order Settings
- 3.7.9 Platform Event Filters
- 3.7.10 Services
- 3.7.11 SMTP Settings
- 3.7.12 SSL Settings
- 3.7.13 System Firewall
- 3.7.14 User Management
- 3.7.15 Video Recording
- 3.7.16 Fan Control
- 3.7.17 PSU Redundancy
- 3.8 Remote Control
- 3.9 Image Redirection
- 3.10 Power Control
- 3.11 Locator LED
- 3.12 Maintenance
- Appendix
3-50
Chapter 3: Web-based User Interface
IP Address Firewall Rules
This page allows you to create and manage existing firewall settings based on IP.
• Existing IP Rules
This page displays the list of existing IP firewall rules.
• To view the page, the user must at least have Operator privileges.
• To add or delete a firewall, the user must have Administrator privileges.
• To ensure the date and time of the firewall rule works properly, make sure to set the
BMC system time before setting the firewall.
• Click on the
x
icon to delete a IP firewall rule from the list.
• Add New IP Rule
This page allows you to add IP firewall settings for the BMC.
IP Single (or) Range Start
Enter the start IP Address or start of a Range of
IP Addresses. IP Address must follow the IPv4
Address format.
• Consists of 4 sets of numbers
separated by dots as in ‘xxx.xxx.xxx.
xxx’.
• Each set ranges from 0 to 255.
• First number cannot be 0.
IP Range End
Used to indicate the IP Address or end of an IP
address range.
(continued on the next page)
Start Date
The firewall rule will become effective from this
date.
This item is only configurable if
Timeout
is
enabled.
Start Time
The firewall rule will become effective from this
time.
This item is only configurable if
Timeout
is
enabled.
End Date
The firewall rule will expire on this date.
This item is only configurable if
Timeout
is
enabled.
End Time
The firewall rule will expire at this time.
This item is only configurable if
Timeout
is
enabled.