User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Installation Information
- Chapter 3: Web-based User Interface
- 3.1 Web-based user interface
- 3.2 Dashboard
- 3.3 Sensor
- 3.4 System Inventory
- 3.5 FRU Information
- 3.6 Logs & Reports
- 3.7 Settings
- 3.7.1 Date & Time
- 3.7.2 External User Services
- 3.7.3 KVM Mouse Setting
- 3.7.4 Log Settings
- 3.7.5 Manage Licenses
- 3.7.6 Media Redirection Settings
- 3.7.7 Network Settings
- 3.7.8 PAM Order Settings
- 3.7.9 Platform Event Filters
- 3.7.10 Services
- 3.7.11 SMTP Settings
- 3.7.12 SSL Settings
- 3.7.13 System Firewall
- 3.7.14 User Management
- 3.7.15 Video Recording
- 3.7.16 Fan Control
- 3.7.17 PSU Redundancy
- 3.8 Remote Control
- 3.9 Image Redirection
- 3.10 Power Control
- 3.11 Locator LED
- 3.12 Maintenance
- Appendix
ASUS IPMI Expansion Card
3-19
3.7.2 External User Services
This page allows you to set the LDAP/E-directory Settings, Active directory Settings, and
RADIUS Settings.
PTP Inbound Latency
Configure an inbound latency of the server to use when
automatically settings the date and time.
This item is only configurable if
Automatic PTP
Date & Time
is set to enabled.
PTP Outbound Latency
Configure a PTP outbound latency of the server to use
when automatically settings the date and time.
This item is only configurable if
Automatic PTP
Date & Time
is set to enabled.
PTP Priority1
Configure a priority of PTP clock to use when
automatically settings the date and time.
This item is only configurable if
Automatic PTP
Date & Time
is set to enabled.
PTP Max Master capacity
Configure a max master capacity of the PTP clock to use
when automatically settings the date and time.
This item is only configurable if
Automatic PTP
Date & Time
is set to enabled.
PTP Log request delay
Configure a PTP log request delay, use when
automatically settings the date and time.
This item is only configurable if
Automatic PTP
Date & Time
is set to enabled.
Panic Mode
Configure PTP clock to not reset if jump is more than 1
second, use when automatically settings the date and
time.
This item is only configurable if
Automatic PTP
Date & Time
is set to enabled.