User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Installation Information
- Chapter 3: Web-based User Interface
- 3.1 Web-based user interface
- 3.2 Dashboard
- 3.3 Sensor
- 3.4 System Inventory
- 3.5 FRU Information
- 3.6 Logs & Reports
- 3.7 Settings
- 3.7.1 Date & Time
- 3.7.2 External User Services
- 3.7.3 KVM Mouse Setting
- 3.7.4 Log Settings
- 3.7.5 Manage Licenses
- 3.7.6 Media Redirection Settings
- 3.7.7 Network Settings
- 3.7.8 PAM Order Settings
- 3.7.9 Platform Event Filters
- 3.7.10 Services
- 3.7.11 SMTP Settings
- 3.7.12 SSL Settings
- 3.7.13 System Firewall
- 3.7.14 User Management
- 3.7.15 Video Recording
- 3.7.16 Fan Control
- 3.7.17 PSU Redundancy
- 3.8 Remote Control
- 3.9 Image Redirection
- 3.10 Power Control
- 3.11 Locator LED
- 3.12 Maintenance
- Appendix
2-8
Chapter 2: Hardware Information
OS Watchdog Timer
This item allows you to start a BIOS timer which can only be shut off by Intel Management
Software after the OS loads.
Configuration options: [Disabled] [Enabled]
The following items is configurable only when the
OS Watchdog Timer
is set to
[Enabled]
.
OS Wtd Timer Timeout
Allows you to configure the length fo the OS Boot Watchdog Timer.
Configuration options: [5 minutes] [10 minutes] [15 minutes] [20 minutes]
OS Wtd Timer Policy
This item allows you to configure the how the system should respond if the OS Boot
Watch Timer expires.
Configuration options: [Do Nothing] [Reset] [Power Down]
MLED light Synchronizing
Allows you to synchronize the left LAN port LED of the IPMI Expansion card with the Message
LED.
Configuration options: [Disabled] [Enabled]
BMC_LED light synchronizing
Allows you to synchronize the right LAN port LED of the IPMI Expansion card with the BMC_
LED.
Configuration options: [Disabled] [Enabled]
2.3.3 System Event Log
Allows you to change the SEL event log configuration.
All values changed here do not take effect until computer is restarted.
Erase SEL
Allows you to choose options for erasing SEL.
Configuration options: [No] [Yes, On next reset] [Yes, On every reset]