User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Installation Information
- Chapter 3: Web-based User Interface
- 3.1 Web-based user interface
- 3.2 Dashboard
- 3.3 Sensor
- 3.4 System Inventory
- 3.5 FRU Information
- 3.6 Logs & Reports
- 3.7 Settings
- 3.7.1 Date & Time
- 3.7.2 External User Services
- 3.7.3 KVM Mouse Setting
- 3.7.4 Log Settings
- 3.7.5 Manage Licenses
- 3.7.6 Media Redirection Settings
- 3.7.7 Network Settings
- 3.7.8 PAM Order Settings
- 3.7.9 Platform Event Filters
- 3.7.10 Services
- 3.7.11 SMTP Settings
- 3.7.12 SSL Settings
- 3.7.13 System Firewall
- 3.7.14 User Management
- 3.7.15 Video Recording
- 3.7.16 Fan Control
- 3.7.17 PSU Redundancy
- 3.8 Remote Control
- 3.9 Image Redirection
- 3.10 Power Control
- 3.11 Locator LED
- 3.12 Maintenance
- Appendix
ASUS IPMI Expansion Card
1-5
USB header:
Connects to motherboard USB 2.0 front header for data transfer and KVM
keyboard/mouse remote control.
To use the keyboard and mouse function for KVM remote control, ensure the
USB header
is
connected to the USB 2.0 connector on the motherboard.
PSU PM_BUS header:
Connects to power supply for PSU detection.
• Power supply needs to support PSU function.
• To use the PSU sensor and power redundancy settings function, ensure the power
supply is connected to the
PSU PM_BUS header
, and the
SMART_PSU switch
jumper
is set to
Enable
.
6-pin PSU connector:
Connects to PCIE power +12V for fan power.
To use the CHA FAN sensor and control function, ensure the fans are connected to the
Fan
headers 1-8
, and the
6-pin PSU connector
is connected to a power supply.
VGA switch jumper:
Used to turn on/off the display; default set to On.
LOC switch jumper:
Used to toggle heartbeat LED lit up/breathing.
BMC switch jumper:
Used to turn on/off the BMC card.
SMART_PSU switch jumper:
Used for controlling alert.
• Power supply needs to support PSU function.
• To use the PSU sensor and power redundancy settings function, ensure the power
supply is connected to the
PSU PM_BUS header
, and the
SMART_PSU switch
jumper
is set to
Enable
.
LAN IP mode switch jumper:
Used to control LAN IP - Dynamic/Fixed(10.10.10.10).