User Manual
Table Of Contents
- 1. Knowing BIOS
- 2. BIOS setup program
- 3. Managing and updating your BIOS
- 4. BIOS menu screen
- 5. Main menu
- 6. Ai Tweaker menu
- 7. Advanced menu
- 7.1 Platform Misc Configuration
- 7.2 CPU Configuration
- 7.3 System Agent (SA) Configuration
- 7.4 PCH Configuration
- 7.5 PCH Storage Configuration
- 7.6 PCH-FW Configuration
- 7.7 AMT Configuration
- 7.8 Thunderbolt(TM) Configuration
- 7.9 Trusted Computing
- 7.10 Redfish Host Interface Settings
- 7.11 Serial Port Console Redirection
- 7.12 Intel TXT Information
- 7.13 PCI Subsystem Settings
- 7.14 USB Configuration
- 7.15 Network Stack Configuration
- 7.16 NVMe Configuration
- 7.17 HDD/SSD SMART Information
- 7.18 APM Configuration
- 7.19 Onboard Devices Configuration
- 7.20 Intel(R) Rapid Storage Technology
- 8. Monitor menu
- 9. Boot menu
- 10. Tool menu
- 11. IPMI menu
- 12. Exit menu
Pro WS W680-ACE Series BIOS Manual
53
Parity
A parity bit can be sent with the data bits to detect some transmission errors. [Mark]
and [Space] parity do not allow for error detection. They can be used as an additional
data bit.
[None] None
[Even] Parity bit is 0 if the num of 1’s in the data bits is even.
[Odd] Parity bit is 0 if num of 1’s in the data bits is odd.
[Mark] Parity bit is always 1.
[Space] Parity bit is always 0.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning.)
The standard setting is 1 stop bit. Communication with slow devices may require more
than 1 stop bit.
Configuration options: [1] [2]
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a “stop” signal can be sent to stop the data flow. Once the
buffers are empty, a “start” signal can be sent to re-start the flow. Hardware flow
control uses two wires to send start/stop signals.
Configuration options: [None] [Hardware RTS/CTS]
VT -UTF8 Combo Key Support
This allows you to enable the VT -UTF8 Combination Key Support for ANSI/VT100
terminals.
Configuration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
Configuration options: [Disabled] [Enabled]
Resolution 100x31
This allows you enable or disable extended terminal solution.
Configuration options: [Disabled] [Enabled]
Putty Keypad
This allows you to select the FunctionKey and Keypad on Putty.
Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
Legacy Console Redirection Settings
Redirection COM Port
Allows you to select a COM port to display redirection of Legacy OS and Legacy
OPROM Messages.
Configuration options: [COM0] [COM1(Pci Bus0, Dev22, Func3, Port0)]
Resolution
This allows you to set the number of rows and columns supported on the Legacy OS.
Configuration options: [80x24] [80x25]