User Manual
Table Of Contents
- 1. Knowing BIOS
- 2. BIOS setup program
- 3. Managing and updating your BIOS
- 4. BIOS menu screen
- 5. Main menu
- 6. Ai Tweaker menu
- 7. Advanced menu
- 7.1 Platform Misc Configuration
- 7.2 CPU Configuration
- 7.3 System Agent (SA) Configuration
- 7.4 PCH Configuration
- 7.5 PCH Storage Configuration
- 7.6 PCH-FW Configuration
- 7.7 AMT Configuration
- 7.8 Thunderbolt(TM) Configuration
- 7.9 Trusted Computing
- 7.10 Redfish Host Interface Settings
- 7.11 Serial Port Console Redirection
- 7.12 Intel TXT Information
- 7.13 PCI Subsystem Settings
- 7.14 USB Configuration
- 7.15 Network Stack Configuration
- 7.16 NVMe Configuration
- 7.17 HDD/SSD SMART Information
- 7.18 APM Configuration
- 7.19 Onboard Devices Configuration
- 7.20 Intel(R) Rapid Storage Technology
- 8. Monitor menu
- 9. Boot menu
- 10. Tool menu
- 11. IPMI menu
- 12. Exit menu
Pro WS W680-ACE Series BIOS Manual
27
Second Point Frequency
Allows you to specify the frequency for the given point. 0-MRC auto, else a specific
frequency as an integer: 2000Mhz.
Configuration options: [0] - [65535]
Second Point Gear
Allows you to set the gear ratio for this SAGV point. 0-Auto, 1-G1, 2-G2, 4-G4.
Configuration options: [0] - [4]
Third Point Frequency
Allows you to specify the frequency for the given point. 0-MRC auto, else a specific
frequency as an integer: 2000Mhz.
Configuration options: [0] - [65535]
Third Point Gear
Allows you to set the gear ratio for this SAGV point. 0-Auto, 1-G1, 2-G2, 4-G4.
Configuration options: [0] - [4]
The Fourth Point Gear will always be the settings you set in the main menu, so configure
the Fourth Point Gear there.
Digi+ VRM
VRM Intialization Check
When any error occurs during VRM initialization, the system will hang at POST code
76/77 if this function is enabled.
Configuration options: [Disabled] [Enabled]
CPU Input Voltage Load-line Calibration
Configuration options [Auto] [Level 1] [Level 2] [Level 3]
CPU Load-line Calibration
The load-line is defined by the Intel VRM specification and affects the level of voltage
supplied to the processor. Higher load-line calibration settings result in reduced
VDroop at the expense of voltage overshoot and will increase CPU temperatures due
to higher voltage under load. Select from level 1 to 7 to adjust the load-line slope.
Level 1 = greater VDroop, Level 7 = minimum VDroop.
Configuration options [Auto] [Level 1] [Level 2] [Level 3] [Level 4:Recommended for
OC] [Level 5] [Level 6] [Level 7]
The actual performance boost may vary depending on your CPU specification.
DO NOT remove the thermal module. The thermal conditions should be monitored.
Synch ACDC Loadline with VRM Loadline
Enable this item to allow the VRM Loadline to be adjusted automatically to match the
AC/DC Loadline.
Configuration options: [Disabled] [Enabled]