User Manual
Table Of Contents
- About this guide
- Intel® RAID Configuration
- 1. RAID definitions
- 2. Installing storage devices
- 3. Creating a SATA RAID set in UEFI BIOS
- 4. Creating a SATA RAID set in BIOS
- 5. Creating an NVMe RAID set with onboard M.2 modules in UEFI BIOS
- 6. Creating an NVMe RAID set with onboard M.2/PCIe storage modules in BIOS
- 7. Creating an NVMe RAID set with expansion M.2 card in UEFI BIOS
- 8. Creating an NVMe RAID set with expansion M.2 card in BIOS
- 9. Installing the RAID controller driver during Windows® 10 or Windows® 11 OS installation
Intel
®
RAID Configuration Guide
1-31
8. Creating an NVMe RAID set with expansion M.2 card
in BIOS
Some BIOS options may differ, but the steps remain the same.
1. Install the VROC key to the motherboard.
Refer to your motherboard’s user guide for the location of the VROC Key slot.
2. Power on your board and enter the BIOS Setup during POST.
Refer to Chapter 3 in your motherboard’s user guide for details on entering and navigating
through the BIOS Setup.
3. Go to Advanced > Sytem Storage Configuration for VROC.
4. Set the PCIe slot with the expansion M.2 card to [Enabled].
NVMe RAID support varies between different motherboard models. Make sure to check
the product specification for more information.