User Manual
Table Of Contents
- 1. Knowing BIOS
- 2. BIOS setup program
- 3. Managing and updating your BIOS
- 4. BIOS menu screen
- 5. Main menu
- 6. Ai Tweaker menu
- 7. Advanced menu
- 7.1 Trusted Computing
- 7.2 AMD fTPM configuration
- 7.3 Redfish Host Interface Settings
- 7.4 UEFI Variables Protection
- 7.5 Serial Port Console Redirection
- 7.6 CPU Configuration
- 7.7 PCI Subsystem Settings
- 7.8 USB Configuration
- 7.9 Network Stack Configuration
- 7.10 NVMe Configuration
- 7.11 HDD/SSD SMART Information
- 7.12 SATA Configuration
- 7.13 APM Configuration
- 7.14 Onboard Devices Configuration
- 7.15 PCIe Redriver Tuning
- 7.16 AMD Mem Configuration Status
- 7.17 AMD PBS
- 7.18 AMD Overclocking
- 7.19 AMD CBS
- 7.20 Third-party UEFI driver configurations
- 8. Monitor menu
- 9. Boot menu
- 10. Tool menu
- 11. Server Mgmt menu
- 12. Exit menu
76
Pro WS sTR5 Series BIOS Manual
The following items appear only when MBIST Enable is set to [Enabled].
MBIST Test Mode
Allows you to select the MBIST Test Mode - Interface Mode (Tests Single and
Multiple CS transactions and Basic Connectivity) or Data Eye Mode (Measures
Voltage vs. Timing).
Configuration options: [Interface Mode] [Data Eye Mode] [Both] [Auto]
MBIST Aggressors
Allows you to enable or disable Memory Aggressor test.
Configuration options: [Disabled] [Enabled] [Auto]
MBIST Per Bit Slave Die Reporting
Reports 2D Data Eye Results in ABL Log for each DQ, Chipselect, and
Channel.
Configuration options: [Disabled] [Enabled] [Auto]
Data Eye
Pattern Select
Configuration options: [PRBS] [SSO] [Both]
Pattern Length
This token helps to determine the pattern length. The possible options
are 3..C (input hex number, not decimal).
Configuration options: [3] - [C]
Aggressor Channel
This helps read the aggressors channels. If set to [Enabled], you can
read from one or more than one aggressor channel. The default is set
to [Disabled].
Configuration options: [Disabled] [1 Aggressor Channel] [3 Aggressor
Channels] [7 Aggressor Channels]
Aggressor Static Lane Control
Allows you to control the Aggressor Static Lane Controls if enabled.
Configuration options: [Disabled] [Enabled]
The following items appear only when Aggressor Static Lane Control is set to
[Enabled].
Aggressor Static Lane Select Upper 32 bits
Static Lane Select for Upper 32 bits. The bit mask represents the bits
to be read.
Configuration options: [0] - [99999999]
Aggressor Static Lane Select Lower 32 bits
Static Lane Select for Lower 32 bits. The bit mask represents the bits
to be read.
Configuration options: [0] - [99999999]
Aggressor Static Lane Select ECC
Static Lane Select for ECC Lanes. The bit mask represents the bits to
be read.
Configuration options: [0] - [9]
Aggressor Static Lane Value
Configuration options: [0] - [9]
Target Static Lane Control
Allows you to enable or disable Mbist Target Static Lane Control.
Configuration options: [Disabled] [Enabled]