User Manual
Table Of Contents
- 1. Knowing BIOS
- 2. BIOS setup program
- 3. Managing and updating your BIOS
- 4. BIOS menu screen
- 5. Main menu
- 6. Ai Tweaker menu
- 7. Advanced menu
- 7.1 Trusted Computing
- 7.2 AMD fTPM configuration
- 7.3 Redfish Host Interface Settings
- 7.4 UEFI Variables Protection
- 7.5 Serial Port Console Redirection
- 7.6 CPU Configuration
- 7.7 PCI Subsystem Settings
- 7.8 USB Configuration
- 7.9 Network Stack Configuration
- 7.10 NVMe Configuration
- 7.11 HDD/SSD SMART Information
- 7.12 SATA Configuration
- 7.13 APM Configuration
- 7.14 Onboard Devices Configuration
- 7.15 PCIe Redriver Tuning
- 7.16 AMD Mem Configuration Status
- 7.17 AMD PBS
- 7.18 AMD Overclocking
- 7.19 AMD CBS
- 7.20 Third-party UEFI driver configurations
- 8. Monitor menu
- 9. Boot menu
- 10. Tool menu
- 11. Server Mgmt menu
- 12. Exit menu
Pro WS sTR5 Series BIOS Manual
47
SATA6G
Allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
SATA6G Hot Plug
Designates this port as Hot Pluggable.
Configuration options: [Disabled] [Enabled]
M.2
Allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
Restore AC Power Loss
Allows your system to go to ON state, OFF state, or both states after an AC power loss.
When setting your system to [Last State], it goes to the previous state before the AC power
loss.
Configuration options: [Power Off] [Power On] [Last State]
ErP Ready
Allows you to switch off some power at S4+S5 or S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options are switched off. RGB LEDs and
RGB/Addressable RGB Headers will also be disabled.
Configuration options: [Disabled] [Enabled (S4+S5)] [Enabled (S5)]
Power On By PCI-E
Allows you to enable or disable the Wake-on-LAN function of the onboard LAN controller or
other installed PCI-E LAN cards.
Configuration options: [Disabled] [Enabled]
Power On By RTC
Allows you to enable or disable the RTC (Real-Time Clock) to generate a wake event and
configure the RTC alarm date. When enabled, you can set the days, hours, minutes, or
seconds to schedule an RTC alarm date.
Configuration options: [Disabled] [Enabled]
S3 Mode
Enabling this option might make the system unstable, as the least general power
consumption is already over the specification of standard ATX PSU in S3 mode (5Vsb/3A).
Configuration options: [Disabled] [Enabled]
7.13 APM Configuration
The items in this menu allow you to change the advanced power management settings.