User Manual

Chapter 2: Hardware Setup
2-10
2.5.2 Installing 2.5-inch storage devices
To install 2.5-inch storage devices:
1. Remove the side cover of the chassis. Refer to the
Removing the side cover
section
for more information.
2. Prepare the 2.5-inch storage device and the bundled set of screws.
3. Press and hold the storage device tray latch from both sides, then pull the storage
device tray out from the bay.
4. Carefully push the storage device tray lock pin out of the tray using a suitable tool.
Please refer to the illustration below for the location of the storage device tray lock pin.
Storage device tray lock pin