User Manual

ASUS PRIME J4005I-C
1-3
DDR4 DIMM slots
Install1GB,2GB,4GB,and8GBunbufferednon-ECCDDR4DIMMsintothese
DIMMsockets.
Formoredetails,refertoSystem memory.
System panel connector (10-1 pin F_PANEL)
Thisconnectorsupportsseveralchassis-mountedfunctions.
Speaker connector (4-pin SPEAKER)
This4-pinconnectorisforthechassis-mountedsystemwarningspeaker.The
speakerallowsyoutohearsystembeepsandwarnings.
Display panel VCC power selector (VCC_PWR_SEL)
1
3V
(Default)
2
5V
3
12V
VCC_PWR_SEL
Flat panel display brightness connector (8-pin LCD_BLKT_PANEL)
ThisconnectorisfortheLCDpanelbacklightandbrightnesscontrols.Itenables
theLCDpanelbacklight,providesbacklightcontrolsignals,andprovidesbrightness
controlsignalsforthebrightnessbuttononthefrontpanel.
Intel
®
Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~2)
TheseconnectorsconnecttoSerialATA6.0Gb/sharddiskdrivesviaSerialATA
6.0Gb/ssignalcables.
LVDS connector (40-pin LVDS)
ThisconnectorisforanLCDmonitorthatsupportsLow-voltageDifferential
Signaling(LVDS)interface.
Panel switch (2-pin PANEL_SW)
This2-pinheaderisforconnectingamonitorswitchthatcanturnofftheLCDpanel
displaybacklight.
Chassis intrusion connector (4-1 pin CHASSIS)
Thisconnectorisforachassis-mountedintrusiondetectionsensororswitch.
Connectoneendofthechassisintrusionsensororswitchcabletothisconnector.
Thechassisintrusionsensororswitchsendsahigh-levelsignaltothisconnector
whenachassiscomponentisremovedorreplaced.Thesignalisthengenerated
asachassisintrusionevent.
Thechassisintrusiondetectionfeatureisdisabledbydefault.Toenableit,setthe
Chassis Intrude Detect SupportitemintheBIOSto[On].
Pins Setting
1(Default) 3V
2 5V
3 12V