User’s Manual

ASUS PRIME H410M-D
1-3
• M.2slot(KeyM),type2242/2260/2280(supportsSATA&PCIe3.0x2modes).
• M.2slotsupportsdatatransferspeedupto16Gb/s.
• WhenadeviceinSATAmodeisinstalledontheM.2socket,SATA6G_2portcannot
be used.
7. SATA 6Gb/s ports
TheSATA6Gb/sportsallowyoutoconnectSATAdevicessuchasopticaldiscdrivesand
harddiskdrivesviaaSATAcable.
8. USB 3.2 Gen 1 header
TheUSB3.2Gen1headerallowsyoutoconnectaUSB3.2Gen1
moduleforadditionalUSB3.2Gen1ports.TheUSB3.2Gen1header
providesdatatransferspeedofupto5Gb/s.
TheUSB3.2Gen1moduleispurchasedseparately.
9. USB 2.0 header
TheUSB2.0headerallowsyoutoconnectaUSBmoduleforadditionalUSB2.0ports.The
USB2.0headerprovidesdatatransferspeedofupto480Mb/sconnection
speed.
DONOTconnecta1394cabletotheUSBconnectors.Doingsowill
damage the motherboard!
TheUSB2.0moduleispurchasedseparately.
10. Clear CMOS header
ThisheaderallowsyoutocleartheCMOSRTCRAMdataofthesystem
setupinformationsuchasdate,time,andsystempasswords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
 2. Useametalobjectsuchasascrewdrivertoshortthetwopins.
 3. PlugthepowercordandturnONthecomputer.
4. Hold down the <Del>keyduringthebootprocessandenterBIOSsetuptore-
enter data.
Ifthestepsabovedonothelp,removetheonboardbatteryandshortthetwopinsagainto
cleartheCMOSRTCRAMdata.AfterclearingtheCMOS,reinstallthebattery.
11. Front panel audio header
Thisheaderisforachassis-mountedfrontpanelaudioI/OmodulethatsupportsHDaudio
standard.ConnectoneendofthefrontpanelaudioI/Omodulecabletothisheader.
USB3+5V
IntA_P1_SSRX-
IntA_P1_SSRX+
GND
IntA_P1_SSTX-
IntA_P1_SSTX+
GND
IntA_P1_D-
IntA_P1_D+
GND
PIN 1
USB3+5V
IntA_P2_SSRX-
IntA_P2_SSRX+
GND
IntA_P2_SSTX-
IntA_P2_SSTX+
GND
IntA_P2_D-
IntA_P2_D+
CLRTC
+3V_BAT GND
PIN 1
PIN 1
USB+5V USB_P1- USB_P1+ GND NC
USB+5V
USB_P2-
USB_P12+
GND