User’s Manual

ASUS PRIME H310I-PLUS R2.0
1-3
USB 3.1 Gen 1 (up to 5Gbps) connector (20-1pin U31G1_12)
ConnectaUSB3.1Gen1moduletothisconnectorforadditionalUSB3.1
Gen1frontorrearpanelports.ThisconnectorcomplieswithUSB3.1Gen1
specicationsandprovidesfasterdatatransferspeedsofupto5Gbps,faster
chargingtimeforUSB-chargeabledevices,optimizedpowerefciency,and
backwardcompatibilitywithUSB2.0.
Intel
®
H310 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
TheseconnectorsconnecttoSerialATA6.0Gb/sharddiskdrivesviaSerialATA
6.0Gb/ssignalcables.
M.2 socket 3
ThissocketallowsyoutoinstallanM.2(NGFF)SSDmodule.
M.2(SOCKET3)
• ThisM.2socketsupportsMKeyand2260/2280storage
devices.
• WhenadeviceinSATAmodeisinstalledontheM.2socket,
SATA_2portcannotbeused.
PCI Express 3.0/2.0 x16 slot
ThismotherboardhasaPCIExpress3.0/2.0x16slotthatsupportsPCIExpress
3.0/2.0x16graphiccardscomplyingwiththePCIExpressspecications.
Digital audio connector (4-1 pin SPDIF_OUT)
ConnecttheS/PDIFOutmodulecabletothisconnector,
theninstallthemoduletoaslotopeningatthebackofthe
systemchassis.
Clear RTC RAM (2-pin CLRTC)
ThisheaderallowsyoutocleartheCMOSRTCRAMdata
ofthesystemsetupinformationsuchasdate,time,and
systempasswords.
To erase the RTC RAM:
1. TurnOFFthecomputerandunplugthepowercord.
2. Useametalobjectsuchasascrewdrivertoshortthe
twopins.
3. PlugthepowercordandturnONthecomputer.
4. Holddownthe<Del>keyduringthebootprocess
andenterBIOSsetuptore-enterdata.
Ifthestepsabovedonothelp,removetheonboardbatteryandshortthetwopinsagain
tocleartheCMOSRTCRAMdata.AfterclearingtheCMOS,reinstallthebattery.
M.2 Wi-Fi Slot (E-key, type 2230)
ThisconnectorallowsyoutoconnectaM.2Wi-Fimodule(E-key,type2230)
SPDIF_OUT
+5V SPDIFOUT GND
PIN 1
CLRTC
+3V_BAT GND
PIN 1