User Guide

ASUS PRIME B360M-A
1-3
TPM connector (14-1 pin TPM)
ThisconnectorsupportsaTrustedPlatformModule(TPM)system,whichcan
securelystorekeys,digitalcerticates,passwordsanddata.ATPMsystem
alsohelpsenhancenetworksecurity,protectsdigitalidentities,andensures
platformintegrity.
Intel
®
B360 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~6)
TheseconnectorsconnecttoSerialATA6.0Gb/sharddiskdrivesviaSerial
ATA6.0Gb/ssignalcables.
Chassis intrusion header (4-1 pin CHASSIS)
Thisheaderisforachassis-mountedintrusiondetectionsensororswitch
Connectoneendofthechassisintrusionsensororswitchcabletothis
header.Thechassisintrusionsensororswitchsendsahigh-levelsignaltothis
headerwhenachassiscomponentisremovedorreplaced.Thesignalisthen
generatedasachassisintrusionevent.
Bydefault,thepinlabeled“ChassisSignal”and“Ground”areshortedwitha
jumpercap.Removethejumpercapsonlywhenyouintendtousethechassis
intrusiondetectionfeature.
System panel connector (10-1 pin F_PANEL)
Thisconnectorsupportsseveralchassis-mountedfunctions.
Speaker connector (4-pin SPEAKER)
This4-pinconnectorisforthechassis-mountedsystemwarningspeaker.The
speakerallowsyoutohearsystembeepsandwarnings.
USB 2.0 connectors (10-1 pin USB914, USB1011)
ConnecttheUSBmodulecabletoanyoftheseconnectors,theninstallthe
moduletoaslotopeningatthebackofthesystemchassis.TheseUSB
connectorscomplywithUSB2.0specicationsandsupportupto480Mbps
connectionspeed.
RGB header (4-pin RGB_HEADER)
ThisheaderisforRGBLEDstrips.
TheRGBheadersupports5050RGBmulti-colorLEDstrips(12V/G/R/B),witha
maximumpowerratingof3A(12V),andnolongerthan3m.
Beforeyouinstallorremoveanycomponent,ensurethattheATXpowersupplyis
switchedofforthepowercordisdetachedfromthepowersupply.Failuretodoso
maycauseseveredamagetothemotherboard,peripherals,orcomponents.
• ActuallightingandcolorwillvarywithLEDstrip.
• IfyourLEDstripdoesnotlightup,checkiftheRGBLEDextensioncable
andtheRGBLEDstripisconnectedinthecorrectorientation,andthe12V
connectorisalignedwiththe12Vheaderonthemotherboard.
• TheLEDstripwillonlylightupwhenthesystemisoperating.
• TheLEDstripsarepurchasedseparately.