User Manual

1-2
Chapter 1: Product introduction
ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
CorrectlyorienttheATXpowersupplyplugsintotheseconnectorsandpushdown
rmlyuntiltheconnectorscompletelyt.
• Forafullyconguredsystem,werecommendthatyouuseapowersupply
unit(PSU)thatcomplieswithATX12VSpecication2.0(orlaterversion)
andprovidesaminimumpowerof350W.ThisPSUtypehas24-pinand
8-pin power plugs.
• DONOTforgettoconnectthe8-pinEATX+12Vpowerplug.Otherwise,
the system will not boot up.
• WerecommendthatyouuseaPSUwithhigherpoweroutputwhen
conguringasystemwithmorepower-consumingdevicesorwhenyou
intendtoinstalladditionaldevices.Thesystemmaybecomeunstableor
may not boot up if the power is inadequate.
• If you are uncertain about the minimum power supply requirement for your
system,refertotheRecommendedPowerSupplyWattageCalculatorat
http://support.asus.com.cn/PowerSupply.aspx?SLanguage=en for details.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN1~2)
Connectthefancablestothefanconnectorsonthemotherboard,ensuringthatthe
black wire of each cable matches the ground pin of the connector.
Donotforgettoconnectthefancablestothefanconnectors.Insufcientair
owinsidethesystemmaydamagethemotherboardcomponents.Theseare
notjumpers!Donotplacejumpercapsonthefanconnectors!TheCPU_FAN
connectorsupportsaCPUfanofmaximum1A(12W)fanpower.
Intel
®
LGA1151 CPU socket
Install Intel
®
LGA1151CPUintothissurfacemountLGA1151socket,whichis
designed for 8th Generation Intel
®
Core™i7/i5/i3,Pentium
®
,andCeleron
®
processors.
Formoredetails,refertoCentral Processing Unit (CPU).
DDR4 DIMM slots
Install2GB,4GB,8GB,and16GBunbufferednon-ECCDDR4DIMMsintothese
DIMMsockets.
Formoredetails,refertoSystem memory.