User Manual

Rev 2.3-1.0.1
Mellanox Technologies
129
ration. The IPoIB configuration file can specify either or both of the following data for an IPoIB
interface:
• A static IPoIB configuration
• An IPoIB configuration based on an Ethernet configuration
See your Linux distribution documentation for additional information about configuring IP
addresses.
The following code lines are an excerpt from a sample IPoIB configuration file:
# Static settings; all values provided by this file
IPADDR_ib0=11.4.3.175
NETMASK_ib0=255.255.0.0
NETWORK_ib0=11.4.0.0
BROADCAST_ib0=11.4.255.255
ONBOOT_ib0=1
# Based on eth0; each '*' will be replaced with a corresponding octet
# from eth0.
LAN_INTERFACE_ib0=eth0
IPADDR_ib0=11.4.'*'.'*'
NETMASK_ib0=255.255.0.0
NETWORK_ib0=11.4.0.0
BROADCAST_ib0=11.4.255.255
ONBOOT_ib0=1
# Based on the first eth<n> interface that is found (for n=0,1,...);
# each '*' will be replaced with a corresponding octet from eth<n>.
LAN_INTERFACE_ib0=
IPADDR_ib0=11.4.'*'.'*'
NETMASK_ib0=255.255.0.0
NETWORK_ib0=11.4.0.0
BROADCAST_ib0=11.4.255.255
ONBOOT_ib0=1
3.2.5.1.2.5 Manually Configuring IPoIB
This manual configuration persists only until the next reboot or driver restart.
To manually configure IPoIB for the default IB partition (VLAN), perform the following steps:
Step 1. To configure the interface, enter the ifconfig command with the following items:
• The appropriate IB interface (ib0, ib1, etc.)
• The IP address that you want to assign to the interface
• The netmask keyword
• The subnet mask that you want to assign to the interface
The following example shows how to configure an IB interface:
host1$ ifconfig ib0 11.4.3.175 netmask 255.255.0.0