User Manual

Rev 4.60
Mellanox Technologies
93
8.3.18 iblinkinfo
iblinkinfo reports link info for each port in an IB fabric, node by node. Optionally, iblinkinfo can
do partial scans and limit its output to parts of a fabric.
8.3.18.1 iblinkinfo Synopsis
8.3.18.2 iblinkinfo Flags and Options
[-hcdl -C <ca_name> -P <ca_port> -p -S <port_guid> -G <port_guid> -D
<direct_route> --load-cache <filename>]
Table 27 - iblinkinfo Flags and Options
Flags Description
-S <port_guid> -G <port_guid> --port-guid Starts partial scan at the port specified by <port_guid>
(hex format)
-D <direct_route> Starts partial scan at the port specified by the direct route
path.
-l Prints all information for each link on one line. Default is to
print a header with the node information and then a list for
each port (useful for grep´ing output).
-d Prints only nodes which have a port in the "Down" state.
-p Prints additional port settings (<Life-
Time>,<HoqLife>,<VLStall-Count>)
-C <ca_name> Uses the specified ca_name for the search.
-P <ca_port> Uses the specified ca_port for the search.
-R (This option is obsolete and does nothing)
--load-cache <filename> Loads and use the cached ibnetdiscover data stored in the
specified filename. May be useful for outputting and learn-
ing about other fabrics or a previous state of a fabric. Can-
not be used if user specifies a direct route path. See
ibnetdiscover for information on caching ibnetdiscover out-
put.
--diff <filename> Loads cached ibnetdiscover data and do a diff comparison
to the
current network or another cache. A special diff output
for iblinkinfo output will be displayed showing differences
between the old and current fabric links. Be default, the fol-
lowing are compared for differences: port connections and
port state. See ibnetdiscover for information on caching
ibnetdiscover output.