User Manual

Rev 2.2-1.0.1
Mellanox Technologies
291
Additional Options
The table below lists the additional flags of the command
Table 66 - Additional raw_ethernet_lat Flags and Options
Flag Description
--inline_recv=<size> Max size of message to be sent in inline receive
--output=<units> Set verbosity output level: bandwidth , message_rate,
latency_typical
--pkey_index=<pkey index> PKey index to use for QP
.
Raw Ethernet Options
The table below lists the Raw Ethernet flags of the command.
-r, --rx-depth=<dep> Rx queue size (default 512). If using srq, rx-depth con-
trols max-wr size of the srq
-R, --rdma_cm Connect QPs with rdma_cm and run test on those QPs
-s, --size=<size> Size of message to exchange (default 2)
-S, --sl=<sl> SL (default 0)
-T, --tos=<tos value> Set <tos_value> to RDMA-CM QPs. availible only with
-R flag. values 0-256 (default of
f)
-u, --qp-timeout=<timeout> QP timeout, timeout value is 4 usec * 2 ^(timeout),
default 14
-U, --report-unsorted (implies -H) print out unsorted results (default sorted)
-V, --version Display version number
-x, --gid-index=<index> Test uses GID with GID index (Default : IB - no gid .
ETH - 0)
-z, --com_rdma_cm Communicate with rdma_cm module to exchange data -
use regular QPs
Table 67 - raw_ethernet_lat Raw Ethernet Flags and Options
Flag Description
-B, --source_mac Source MAC address by this format
XX:XX:XX:XX:XX:XX (default take the MAC address
form GID)
Table 65 - raw_ethernet_lat Flags and Options
Flag Description