User Manual

InfiniBand Fabric UtilitiesRev 2.2-1.0.1
Mellanox Technologies
254
-qq burn, query Run a quick query. When specified, mstflint will not
perform full image integrity checks during the query
operation. This may shorten execution time when run
-
ning over slow interfaces (e.g., I2C, MTUSB-1).
-nofs burn Burn image in a non-failsafe manner
-skip_is burn Allow burning the firmware image without updating the
invariant sector. This is to ensure failsafe burning even
when an invariant sector difference is detected.
-byte_mode burn, write Shift address when accessing Flash internal registers.
May be required for burn/write commands when access
-
ing certain Flash types.
-s[ilent] burn Do not print burn progress messages
-y[es] All Non-interactive mode: Assume the answer is “yes” to
all questions.
-no All Non-interactive mode: Assume the answer is “no” to all
questions.
-vsd <string> burn Write this string of up to 208 characters to VSD upon a
burn command.
-use_image_ps burn Burn vsd as it appears in the given image - do not keep
existing VSD on Flash.
-dual_image burn Make the burn process burn two images on Flash. The
current default failsafe burn process burns a single
image (in alternating locations).
-v Print version info
Table 43 - mstflint Commands (Sheet 1 of 2)
Command Description
b[urn] Burn Flash
q[uery] Query miscellaneous Flash/firmware characteristics
v[erify] Verify the entire Flash
bb Burn Block: Burn the given image as is, without running any
checks
Table 42 - mstflint Switches (Sheet 2 of 2)
Switch
Affected/
Relevant
Commands
Description