User Manual

Rev 2.2-1.0.1
Mellanox Technologies
253
Output Files
Table 42 lists the various switches of the utility, and Table 43 lists its commands.
Table 42 - mstflint Switches (Sheet 1 of 2)
Switch
Affected/
Relevant
Commands
Description
-h Print the help menu
-hh Print an extended help menu
-d[evice] <device> All Specify the device to which the Flash is connected.
-guid <GUID> burn, sg GUID base value. 4 GUIDs are automatically assigned
to the following values:
guid -> node GUID
guid+1 -> port1
guid+2 -> port2
guid+3 -> system image GUID.
Note: Port2 guid will be assigned even for a single port HCA; the HCA
ignores this value.
-guids <GUIDs...> burn, sg 4 GUIDs must be specified here. The specified GUIDs
are assigned the following values, repectively: node,
port1, port2 and system image GUID.
Note: Port2 guid must be specified even for a single port
HCA; the HCA ignores this value. It can be set to 0x0.
-mac <MAC> burn, sg MAC address base value. Two MACs are automatically
assigned to the following values:
mac -> port1
mac+1 -> port2
Note: This switch is applicable only for Mellanox Tech-
nologies Ethernet products.
-macs <MACs...> burn, sg Two MACs must be specified here. The specified
MACs are assigned to port1 and port2, repectively.
Note: This switch is applicable only for Mellanox Tech-
nologies Ethernet products.
-blank_guids burn Burn the image with blank GUIDs and MACs (where
applicable). These values can be set later using the sg
command – see
Table 43 below.
-clear_semaphore No com-
mands
allowed
Force clear the Flash semaphore on the device. No com-
mand is allowed when this switch is used.
Warning: May result in system instability or Flash cor-
ruption if the device or another application is currently
using the Flash.
-i[mage] <image> burn, verify Binary image file