User Manual

InfiniBand Fabric Diagnostic UtilitiesRev 2.1-1.0.6
Mellanox Technologies
220
Possible command return values are:
Examples
1. Find Mellanox Technologies’s ConnectX® VPI cards with PCI Express running at 2.5GT/s
and InfiniBand ports at DDR / or Ethernet ports at 10GigE.
> /sbin/lspci -d 15b3:634a
04:00.0 InfiniBand: Mellanox Technologies MT25418 [ConnectX IB DDR, PCIe 2.0 2.5GT/s]
(rev a0).
In the example above, 15b3 is Mellanox Technologies’s vendor number (in hexadecimal), and 634a is
the device’s PCI Device ID (in hexadecimal). The number string 04:00.0 identifies the device in the
form bus:dev.fn.
2. Verify the ConnectX firmware using its ID (using the results of the example above).
> mstflint -d 04:00.0 v
ConnectX failsafe image. Start address: 80000. Chunk size 80000:
NOTE: The addresses below are contiguous logical addresses. Physical addresses on flash
may be different, based on the image start address and chunk size
/0x00000038-0x000010db (0x0010a4)/ (BOOT2) - OK
/0x000010dc-0x00004947 (0x00386c)/ (BOOT2) - OK
/0x00004948-0x000052c7 (0x000980)/ (Configuration) - OK
/0x000052c8-0x0000530b (0x000044)/ (GUID) - OK
/0x0000530c-0x0000542f (0x000124)/ (Image Info) - OK
/0x00005430-0x0000634f (0x000f20)/ (DDR) - OK
/0x00006350-0x0000f29b (0x008f4c)/ (DDR) - OK
/0x0000f29c-0x0004749b (0x038200)/ (DDR) - OK
/0x0004749c-0x0005913f (0x011ca4)/ (DDR) - OK
/0x00059140-0x0007a123 (0x020fe4)/ (DDR) - OK
/0x0007a124-0x0007bdff (0x001cdc)/ (DDR) - OK
/0x0007be00-0x0007eb97 (0x002d98)/ (DDR) - OK
/0x0007eb98-0x0007f0af (0x000518)/ (Configuration) - OK
/0x0007f0b0-0x0007f0fb (0x00004c)/ (Jump addresses) - OK
/0x0007f0fc-0x0007f2a7 (0x0001ac)/ (FW Configuration) - OK
FW image verification succeeded. Image is bootable.
0 - successful completion
1 - error has occurred
7 - the burn command was aborted because firmware is current
The PCI Device IDs of Mellanox Technologies’ devices can be obtained from the PCI
ID Repository Website at http://pci-ids.ucw.cz/read/PC/15b3.