User Manual

Rev 2.1-1.0.6
Mellanox Technologies
219
-vsd
<string>
burn Write this string of up to 208 characters to VSD upon a burn
command.
-
use_image_p
s
burn Burn vsd as it appears in the given image - do not keep existing
VSD on Flash.
-dual_image burn Make the burn process burn two images on Flash. The current
default failsafe burn process burns a single image (in alternat-
ing locations).
-v Print version info
Table 37 - mstflint Commands
Command Description
b[urn] Burn Flash
q[uery] Query miscellaneous Flash/firmware characteristics
v[erify] Verify the entire Flash
bb Burn Block: Burn the given image as is, without running any
checks
sg Set GUIDs
ri <out-file> Read the firmware image on the Flash into the specified file
dc <out-file> Dump Configuration: Print a firmware configuration file for
the given image to the specified output file
e[rase] <addr> Erase sector
rw <addr> Read one DWORD from Flash
ww <addr> < data> Write one DWORD to Flash
wwne <addr> Write one DWORD to Flash without sector erase
wbne <addr>
<size> <data...>
Write a data block to Flash without sector erase
rb <addr> <size>
[out-file]
Read a data block from Flash
swreset SW reset the target InfniScale® IV device. This command is
supported only in the In-Band access method.
Table 36 - mstflint Switches (Sheet 3 of 3)
Switch
Affected/
Relevant
Commands
Description