User Manual

InfiniBand Fabric Diagnostic UtilitiesRev 2.1-1.0.6
Mellanox Technologies
218
-mac
<MAC>
burn, sg MAC address base value. Two MACs are automatically
assigned to the following values:
mac -> port1
mac+1 -> port2
Note: This switch is applicable only for Mellanox Technolo-
gies Ethernet products.
-macs
<MACs...>
burn, sg Two MACs must be specified here. The specified MACs are
assigned to port1 and port2, repectively.
Note: This switch is applicable only for Mellanox Technolo-
gies Ethernet products.
-blank_guids burn Burn the image with blank GUIDs and MACs (where applica-
ble). These values can be set later using the sg command – see
Table 37 below.
-
clear_semap
hore
No com-
mands
allowed
Force clear the Flash semaphore on the device. No command is
allowed when this switch is used.
Warning: May result in system instability or Flash corruption if
the device or another application is currently using the Flash.
-i[mage]
<image>
burn, verify Binary image file
-qq burn, query Run a quick query. When specified, mstflint will not perform
full image integrity checks during the query operation. This
may shorten execution time when running over slow interfaces
(e.g., I2C, MTUSB-1).
-nofs burn Burn image in a non-failsafe manner
-skip_is burn Allow burning the firmware image without updating the
invariant sector. This is to ensure failsafe burning even when
an invariant sector difference is detected.
-byte_mode burn, write Shift address when accessing Flash internal registers. May be
required for burn/write commands when accessing certain
Flash types.
-s[ilent] burn Do not print burn progress messages
-y[es] All Non-interactive mode: Assume the answer is “yes” to all ques-
tions.
-no All Non-interactive mode: Assume the answer is “no” to all ques-
tions.
Table 36 - mstflint Switches (Sheet 2 of 3)
Switch
Affected/
Relevant
Commands
Description