User Manual

> ibcheckerrs -v -T thresh1 2 1
Error check on lid 2 (MT47396 Infiniscale-III Mellanox Technologies) port 1: OK
Rev 2.1-1.0.6
Mellanox Technologies
217
9.15 mstflint
Queries and burns a binary firmware-image file on non-volatile (Flash) memories of Mellanox
InfiniBand and Ethernet network adapters. The tool requires root privileges for Flash access.
To run mstflint, you must know the device location on the PCI bus. See Example 1 for details.
Synopsis
Output Files
Table 36 lists the various switches of the utility, and Table 37 lists its commands.
If you purchased a standard Mellanox Technologies network adapter card, please down-
load the firmware image from www.mellanox.com > Downloads > Firmware. If you
purchased a non-standard card from a vendor other than Mellanox Technologies, please
contact your vendor.
mstflint [switches...] <command> [parameters...]
Table 36 - mstflint Switches (Sheet 1 of 3)
Switch
Affected/
Relevant
Commands
Description
-h Print the help menu
-hh Print an extended help menu
-d[evice]
<device>
All Specify the device to which the Flash is connected.
-guid
<GUID>
burn, sg GUID base value. 4 GUIDs are automatically assigned to the
following values:
guid -> node GUID
guid+1 -> port1
guid+2 -> port2
guid+3 -> system image GUID.
Note: Port2 guid will be assigned even for a single port HCA; the HCA ignores this
value.
-guids
<GUIDs...>
burn, sg 4 GUIDs must be specified here. The specified GUIDs are
assigned the following values, repectively: node, port1, port2
and system image GUID.
Note: Port2 guid must be specified even for a single port HCA;
the HCA ignores this value. It can be set to 0x0.