User Manual

Rev 2.1-1.0.6
Mellanox Technologies
197
Options
Output Files
-n <[src-name,]dst-name>
Names of the source and destination ports (as
defined in the topology file; source may be omit
ted -> local port is assumed to be the source)
-l <[src-lid,]dst-lid>
Source and destination LIDs (source may be omit
ted --> the local port is assumed to be the
source)
-d <p1,p2,p3,...> Directed route from the local node (which is the
source) and the destination node
-c <count> The minimal number of packets to be sent across
each link (default = 100)
-v Enable verbose mode
-t <topo-file> Specifies the topology file name
-s <sys-name> Specifies the local system name. Meaningful only
if a topology file is specified
-i <dev-index> Specifies the index of the device of the port
used to connect to the IB fabric (in case of
multiple devices on the local system)
-p <port-num> Specifies the local device's port number used to
connect to the IB fabric
-o <out-dir> Specifies the directory where the output files
will be placed (default = /tmp)
-lw <1x|4x|12x> Specifies the expected link width
-ls <2.5|5|10> Specifies the expected link speed
-pm Dump all the fabric links, pm Counters into
ibdiagnet.pm
-pc Reset all the fabric links pmCounters
-P <PM=<Trash>> If any of the provided pm is greater then its
provided value, print it to screen
-h|--help Prints the help page information
-V|--version Prints the version of the tool
--vars Prints the tool's environment variables and
their values
Table 28 - ibdiagpath Output Files
Output File Description
ibdiagpath.log A dump of all the application reports generated according to the
provided flags
ibdiagnet.pm A dump of the Performance Counters values, of the fabric links