User Manual

Rev 4.70
Mellanox Technologies
31
Step 7. Verify the IP configuration by running ‘ipconfig’ from a CMD console.
7.2 Configuring the InfiniBand Driver
7.2.1 Modifying IPoIB Configuration
 To modify the IPoIB configuration after installation, perform the following steps:
Step 1. Open Device Manager and expand Network Adapters in the device display pane.
Step 2. Right-click the Mellanox IPoIB Adapter entry and left-click Properties.
Step 3. Click the Advanced tab and modify the desired properties.
> ipconfig
...
Ethernet adapter Local Area Connection 4:
Connection-specific DNS Suffix . :
IP Address. . . . . . . . . . . . : 11.4.12.63
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :
...
The IPoIB network interface is automatically restarted once you finish modifying IPoIB
parameters. Consequently, it might affect any running traffic.